These terminals fit our 2.00mm connector housings that are compatible with the JST-PH balancing plugs. We do not yet have a crimping tool for these terminals (they're too small for our stock tools), but they can be soldered with a fine-tip iron.
Connectors (PDF)-
30pcs for $2.66
-
100pcs for $4.88
-
300pcs for $10.26
-
1,000pcs for $29.31
-
10,000pcs for $255.10
2.00mm Female Terminals (BULK/LOOSE Packaging)
These terminals are cut free from the strip/reel and supplied in bulk/loose form. After years of making servo connectors we found that a lot of time was wasted breaking the terminals off of the strip that they're supplied on (they're manufactured and typically sold on a strip/reel). We also found that most people remove the terminals by twisting them back and forth until the metal breaks. This can result in an obtrusion on the back of the terminal, making it more difficult to slide it into the housing. Just as bad, if you have any significant quantity of terminals on a strip, it constantly gets snagged up on itself like barbed-wire. We circumvent this whole mess and clean-cut these terminals off of the reel and supply them in bulk/loose form. No tangly strip, much more compact, and easier to use! Use the "add to cart" buttons immediately to the right to purchase this item.
 |
 |
 |
 |
|
-
30pcs for $2.42
-
100pcs for $4.44
-
300pcs for $9.32
-
1,000pcs for $26.62
-
10,000pcs for $204.08
2.00mm Female Terminals (REEL/STRIP Packaging)
We also provide the exact same terminals on a strip, if you prefer. We find it is easier to work with loose terminals but some people report that they have an easier time handling the terminals while they are attached to the strip. If your hands aren't very steady, then maybe this will make things easier for you. Use the "add to cart" buttons immediately to the right to purchase this item.
 |
 |
 |
 |
 |