These terminals fit all of our .100" LP Male Housings. Phosphor bronze with gold plating give these terminals the ability to withstand high wear in abusive environments and handle large currents with very low contact resistance. We also sell crimping tools for these terminals. You could also solder them if you desire, although crimping is much easier and more reliable both mechanically and electrically. Please note that these terminals are different than the ones sold for our standard .100" rectangular and servo connectors. These will only work in our LP Connector Housings. Below we sell the terminals both in bulk form, and in strip/reel form - we recommend you go with the former. Take care to calculate how many terminals you will need based on housing size and quantity.
Connectors (PDF)-
30pcs for $3.60
-
100pcs for $10.32
-
300pcs for $24.77
-
1,000pcs for $61.92
-
10,000pcs for $464.40
Gold Male Terminals for .100" (2.54mm) Latching Polarized (LP) Housings (STRIP/REEL Packaging)
We also provide the exact same terminals on a strip, if you prefer. We find it is easier to work with loose terminals but some people report that they have an easier time handling the terminals while they are attached to the strip. If your hands aren't very steady, then maybe this will make things easier for you. Use the "add to cart" buttons immediately to the right to purchase this item.
 |
 |
 |
 |
 |
-
30pcs for $4.32
-
100pcs for $12.38
-
300pcs for $29.72
-
1,000pcs for $74.30 - OUT OF STOCK!!
-
10,000pcs for $557.28 - OUT OF STOCK!!
Gold Male Terminals for .100" (2.54mm) Latching Polarized (LP) Housings (BULK/LOOSE Packaging)
These terminals are cut free from the strip/reel and supplied in bulk/loose form. After years of making servo connectors we found that a lot of time was wasted breaking the terminals off of the strip that they're supplied on (they're manufactured and typically sold on a strip/reel). We also found that most people remove the terminals by twisting them back and forth until the metal breaks. This can result in an obtrusion on the back of the terminal, making it more difficult to slide it into the housing. Just as bad, if you have any significant quantity of terminals on a strip, it constantly gets snagged up on itself like barbed-wire. We circumvent this whole mess and clean-cut these terminals off of the reel and supply them in bulk/loose form. No tangly strip, much more compact, and easier to use! Use the "add to cart" buttons immediately to the right to purchase this item.
 |
 |
 |
 |
|